Tricity Bendix TBG700X Manuel d'utilisateur télécharger pdf (Page 20)

Fitting the Hob into the Worktop

Carry out the building in of the hob as follows:

1. place the seals supplied with the hob on the front edge of the cut out. Then,

place them at 50 mm from the side edges and at 10 mm from the rear edge,

as shown in the diagram, taking

care that the seals meet without

overlapping.

2. Place the hob in the cut out, taking

care that it is centred.

3. Fix the hob with the relevant fixing

clamps, supplied with the injectors

kit (see diagram). When the screws

have been tightened, the excess

seal can be removed.

The edge of the hob forms a double seal

which prevents the ingress of liquids.

Seal

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Pas de commentaire

Tricity Bendix TBG700X Manuel d'utilisateur Page 20