Tricity Bendix TBG700X Manuel d'utilisateur télécharger pdf (Page 19)

Fitting the Hob into the Worktop

Carry out the building in of the hob as follows:

1. place the seals supplied with the hob on the front edge of the cut out. Then, place them at 50

mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking

care that the seals meet without overlapping.

2. Place the hob in the cut out, taking care

that it is centred.

3. Fix the hob with the relevant fixing clamps,

supplied with the injectors kit (see diagram).

When the screws have been tightened,

the excess seal can be removed.

The edge of the hob forms a double seal which

prevents the ingress of liquids.

Seal

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Pas de commentaire

Tricity Bendix TBG700X Manuel d'utilisateur Page 19